This is a shot of a pattern I had seen in Tying Emergers: A Complete Guide. I used pheasant tail fibers
for the tail and body on a size 16 hook. The wing was a piece of Antron yarn tied in at the back of the thorax area. I dubbed a sparse thorax of hare’s ear, then pulled the piece of Antron over the top, loosely, to form a loop. Then it is tied off at the eye of the hook. No hackle. I fished this in the midst of a mayfly hatch and had ok results with it. However, it did not stay in the film long before sinking. So, I could do several things: use a dubbing for abdomen like Super Fine; make sure hook is light wire (it was); experiment with CDC for the loop wing: grease the leader with floatant paste down to the final inch; let if float ’til it sinks, then let it sink and work it back toward the top with slow hand twist retrieve like an emerging mayfly.
Beginning Fly tying, Catch Trout, fly pattern design
Fly Tying: Antron Loop Wing for Emerger

By the way, how’s that book? I’ve been thinking about getting a copy. What would you rate it?
LikeLike
It’s actually, an excellent book for beginner to advanced. They did a nice job. Some innovative stuff in there. I would buy it.
LikeLike
I will put floatant in the loop sometimes – but often i just fish it as is. Often I’m fishing it as a dropper below a dry, so it’s underneath the surface a bit.
LikeLike
I love the loopwing emergers, I only use, antron though (I do not use cdc, I’m too cheap!)
LikeLike
Anthony,
I am curious, do your flies stay in the surface area a reasonable amount of time? Do you put any floatant on the loop?
LikeLike